spec no: dsan4891 rev no: v.2b date: jan/06/2015 page: 1 of 6 approved: wynec checked: allen liu drawn: l.q.xie e rp: 1101032974 t-1 3/4 (5mm) solid state lamp part number: wp7083sydk/j3 super bright yellow features z outstanding material efficiency. z reliable and rugged. z rohs compliant. description the super bright yellow devic e is based on light emitting diode chip made from algainp. package dimensions notes: 1. all dimensions are in millimeters (inches). 2. tolerance is 0.25(0.01") unless otherwise noted. 3. lead spacing is measured where the leads emerge from the package. 4. the specifications, characteristics and technical data descri bed in the datasheet are subject to change without prior notice .
spec no: dsan4891 rev no: v.2b date: jan/06/2015 page: 2 of 6 approved: wynec checked: allen liu drawn: l.q.xie e rp: 1101032974 selection guide notes: 1. 1/2 is the angle from optical centerline where the lumi nous intensity is 1/2 of the optical peak value. 2. luminous intensity/ luminous flux: +/-15%. 3. luminous intensity value is traceable to the cie127-2007 compliant national standards. absolute maximum ratings at ta=25c electrical / optical characteristics at ta=25c notes: 1.wavelength: +/-1nm. 2.forward voltage: +/-0.1v. 3.wavelength value is traceable to the cie127-2007 compliant national standards. 4.excess driving current and/or operating temperature higher t han recommended conditions may result in severe light degradation or premature failure. notes: 1. 1/10 duty cycle, 0.1ms pulse width. 2. 2mm below package base. 3. 5mm below package base. part no. dice lens type v iewing angle [1] min. typ. 2 1/2 wp7083sydk/j3 super bright yellow (algainp) yellow diffused 400 900 60 iv (mcd) [2] @ 20ma symbol parameter device typ. max. units test conditions peak peak wavelength super bright yellow 590 nm i f =20ma d [1] dominant wavelength super bright yellow 590 nm i f =20ma ? 1/2 spectral line half-width super bright yellow 20 nm i f =20ma c capacitance super bright yellow 45 pf v f =0v;f=1mhz v f [2] forward voltage super bright yellow 2 2.5 v i f =20ma i r reverse current super bright yellow 10 ua v r = 5v parameter super bright yellow units power dissipation 75 mw dc forward current 30 ma peak forward current [1] 140 ma reverse voltage 5 v operating/storage temperature -40c to +85c lead solder temperature [2] 260c for 3 seconds lead solder temperature [3] 260c for 5 seconds
spec no: dsan4891 rev no: v.2b date: jan/06/2015 page: 3 of 6 approved: wynec checked: allen liu drawn: l.q.xie e rp: 1101032974 super bright yellow wp7083sydk/j3
spec no: dsan4891 rev no: v.2b date: jan/06/2015 page: 4 of 6 approved: wynec checked: allen liu drawn: l.q.xie e rp: 1101032974 packing & label specifications wp7083sydk/j3 terms and conditions for the usage of this document 1.the information included in this document reflects representative usage scenarios and is intended for technical reference only. 2.the part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. before product ion usage customer should refer to the latest datasheet for the updated specifications. 3.when using the products referenced in this docu ment, please make sure the product is being operated within the environmental and electrical limit s specified in the datasheet. if customer usage exceeds the specified limits, kingbright w ill not be responsible for any subsequent issues. 4.the information in this document applies to typical usage in consumer electronics applications. if customer's application has special reliabilit y requirements or have life-threatening liabilities, such as automotive or medical usage, please co nsult with kingbright representative for further assistance. 5.the contents and information of this document may not be reproduced or re-transmitted without permission by kingbright. 6.all design applications should refer to kingbr ight application notes available at http://www.kingbrightusa. com/applicationnotes
spec no: dsan4891 rev no: v.2b date: jan/06/2015 page: 5 of 6 approved: wynec checked: allen liu drawn: l.q.xie e rp: 1101032974
spec no: dsan4891 rev no: v.2b date: jan/06/2015 page: 6 of 6 approved: wynec checked: allen liu drawn: l.q.xie e rp: 1101032974
|
